This "Test" option will perform a ping and report information on its results. Retrospect for Windows offers a "Test" button located under Configure>Clients>Add. If you can ping other computers successfully, TCP/P is configured properly.? Ping from the Windows computer to another computer, either Windows or Macintosh. (For example, "ping 192.168.6.1".) If it returns information about the computer, it was able to "ping" that address. To do this, start the MS-DOS Prompt program and enter "ping" followed by the computer’s TCP/IP address. You can also test the computer’s connections by "pinging" the computer. If you do not know what your TCP/IP settings should be, consult with your network administrator. "Optain an IP address automatically" should only be selected if your network uses a DHCP server to assign IP addresses. This window’s IP Address tab shows you the IP address and subnet information. To do this, go back to the Network control panel, select TCP/IP for your Ethernet card, and click Properties. If it does not show this you need to check your TCP/IP configurations. This returns information regarding the type of network card, IP address, subnet mask, and default gateway. This should show up in the list of networking components in the Network control panel.Ĭheck your TCP/IP communications by starting the MS-DOS Prompt program and entering "ipconfig -all". While you may have a TCP/IP setting for dial-up networking, you also need one for the network card. Verify the existence of a TCP/IP networking protocol in the Network control panel.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |